Output transistor ON when light is incident. ON when light is interrupted. ON when light is incident. This table continues on the next page. Light-ON ON when light is interrupted. Emitter: Polyvinyl chloride-covered cord, 4-mm dia.
|Published (Last):||19 April 2013|
|PDF File Size:||19.5 Mb|
|ePub File Size:||5.61 Mb|
|Price:||Free* [*Free Regsitration Required]|
Output transistor ON when light is incident. ON when light is interrupted. ON when light is incident. This table continues on the next page. Light-ON ON when light is interrupted. Emitter: Polyvinyl chloride-covered cord, 4-mm dia. Lens M12 x 1 Optical axis 22 0.
Do not exceed a torque of 3. When set properly, the set screw will still extend beyond the adapter wall. Make sure to loosen the set screw before removing the adapter from the sensor. Tighten the coupling nut by hand, not using a tool, until all the threads on the rear of the sensor are covered. This assures a positive connection, important for installations with vibration. Cordset wire colors are shown in parentheses. Do not connect the black wire to the brown wire without a load.
Direct connection of these wires may damage the Photoelectric Sensor AC switching type. When using the Photoelectric Sensor in the vicinity of an inverter motor, be sure to connect the ground wire of the motor to earth. Failure to ground the motor may result in malfunction of the Sensor. To convert millimeters to inches divide by
Page ER1 Note: Standard cable length Models provided with long cable are available. When ordering, specify the cable length by adapting the length of the cable e. Accessories Order Separately Name
E3F2-R2C4 Omron Automation, E3F2-R2C4 Datasheet